EPA Required Water Service Line Inventory

Service Line

How to Identify Your Service Line

Step 1: Locate where your service line enters your home. This is normally located at the lowest level of your home or business visible from a crawlspace or in a utility room. The test area described below, is the most representative portion of the service line that is used to verify material. 

Step 2: Identify the test area. Find the water shut off valve and/or pressure reducer valve (PRV). The test area is located between the shut off valve to the floor or exterior wall. The PRV is normally located after the shut off valve. 

Step 1
Step 2
Step 3: The material type can be identified through a visual inspection, a scratch test, or magnet test. In some situations, the pipe can clearly be identified as plastic or copper. In other situations, due to corrosion the pipe needs to be scratched to reveal either a copper penny color, or silver color. If it is a silver color, the only way to distinguish between galvanized or lead is a magnet test, magnets will stick to galvanized but will not stick to lead.  
Park City

Step 4: Take a picture of your test area, then submit your findings through the Park City Service Line Survey. 

The survey should take around 15 minutes to complete.  If you are unable to locate and/or identify your service line, please reach out to us via email at servicelineinventory@parkcity.gov or by calling us at 385-270-2525.  

Because of the number of homes in Park City, we are prioritizing the inventory of homes built before 1970.  These homes will take precedence when customers require additional support from staff.  Due to new guidance from the Utah Division of Drinking Water, we do not expect homes built after 1970 to be at a high risk of containing lead service lines. However, we are still interested in collecting service line information from homes built after 1970 for potential regulations in the future and making the most robust inventory possible. 

Resources